k-on pedal JHS Legends of Fuzz Mary-K 1969 Kay Fuzz Tone Replica Pedal — Truetone Music

k-on pedal JHS Legends of Fuzz Mary-K 1969 Kay Fuzz Tone Replica Pedal — Truetone MusicKay Musical Instruments was founded by Henry Kay Kuhrmeyer on July 1, 1931. Although Henry quickly shifted production focus to all types of stringed instruments (including basses, violas and guitars), they didnt enter the guitar pedal market until the late 1960s with a series of knobless, treadle based delightfully odd plastic pedals. Each of these four units (the Fuzz Tone F1, Tremolo T1, Wah Wah W1 and Bass Boost B1) were housed in knobless, treadle

Kay Musical Instruments was founded by Henry “Kay” Kuhrmeyer on July 1, 1931. Although Henry quickly shifted production focus to all types of stringed instruments (including basses, violas and guitars), they didn’t enter the guitar pedal market until the late 1960s with a series of  knobless, treadle-based delightfully odd plastic pedals. Each of these four units (the Fuzz Tone F1, Tremolo T1, Wah Wah W1 and Bass Boost B1) were housed in knobless, treadle-based enclosures allowing one parameter of each effect to be adjusted by foot. The Kay Fuzz Tone was most likely released in late 1968/early 1969. Initially designed as a low-cost-version of the Shin-ei/Univox Superfuzz, this fuzz is one of the Edge’s go-to pedals. Fifty-four years later, JHS is releasing their spin on the Kay Fuzz Tone: the Mary-K. They've even added knobs and an expression pedal output for those who want to use it as it was originally intended.

Rather than using a treadle chassis, we allow Mary-K users the option to control the Frequency knob with an expression pedal. They recommend the Nektar NX-P and Roland EV-5 expression pedals, but many other expression pedals should also work. Be advised: some expression pedals may introduce a hum/noise into the signal chain in high electromagnetic interference environments. Therefore, they recommend using plastic chassis expression pedals with short cables to avoid unwanted noise in a high EMI environment.

THIS PEDAL REQUIRES 9V DC NEGATIVE CENTER. 4MA CONSUMPTION. DO NOT USE MORE THAN 9V DC, OR YOUR WARRANTY WILL BE VOIDED. 

THE MARY-K DOES ALLOW FOR BATTERY OPERATION VIA A SINGLE 9V BATTERY. JUST LOOSEN THE TWO REAR SCREWS FROM THE ENCLOSURE AND THE BACKPLATE WILL SWING OPEN. ON THE INSIDE YOU WILL SEE A BATTERY CLIP TO INSTALL THE BATTERY INTO.